Our camper dining room table didn’t really fit too well. It stuck out from the wall and blocked the walkway (which isn’t very wide to begin with). The legs on the inside are in a lot farther from the edge of the table so it looks like it should sit back in there nicely and not bump the wheel cover. It doesn’t. It also looks like it should fit back in beside the wheel cover, but the legs are just a hair too wide. So, we fixed it.
Pop the white cap off the end of the leg that goes in back next to the wheel cover. We measured and determined that we needed to take off 5/8″ – that was taking into account the thickness of the white cap.
Making sure it’s only 5/8″ – it looked like a lot more to me, but we were good.
A pipe cutter is perfect for the job. Measure carefully and be sure you’re cutting the correct leg!
Push the white cap back on and slide the table into place. Perfect fit!
Now the table doesn’t stick out so much…
and it sits back against the camper wall.
Leave a Reply